Install Produce Preserver - Jennair W10779525B Guide D'utilisation Et D'entretien

GETTING STARTED

INSTALL PRODUCE PRESERVER

(ON SOME MODELS)
The produce preserver absorbs ethylene to slow
the ripening process of many produce items.
As a result, certain produce items will stay fresh
longer.
Ethylene production and sensitivity varies
depending on the type of fruit or vegetable.
To preserve freshness, it is best to separate
produce with sensitivity to ethylene from fruits
that produce moderate to high amounts of
ethylene.
Sensitivity to
Ethylene
Apples High
Asparagus Medium
Berries Low
Broccoli High
Cantaloupe Medium
Carrots Low
Citrus Fruit Medium
Grapes Low
Lettuce High
Pears High
Spinach High
14 | GETTING STARTED
INSTALLING THE PRODUCE PRESERVER
CAUTION: IRRITANT
MAY IRRITATE EYES AND SKIN. DANGEROUS FUMES
FORM WHEN MIXED WITH OTHER PRODUCTS.
Do not mix with cleaning products containing ammonia,
bleach or acids. Do not get in eyes, on skin or clothing. Do
not breathe dust. Keep out of reach of children.
FIRST AID TREATMENT: Contains potassium
permanganate. If swallowed, call a Poison Control Center or
doctor immediately. Do not induce vomiting. If in eyes, rinse
with water for 15 minutes. If on skin, rinse with water.
Ethylene
1.
Wash the interior of a crisper drawer with a
Production
solution of mild dish soap and warm water,
Very High
and dry thoroughly.
2.
Very Low
Find the package containing the Produce
Preserver inside the refrigerator, and install
Low
the Produce Preserver into the crisper
drawer according to the instructions
Very Low
provided in the package.
High
INSTALLING THE STATUS INDICATOR
(ON SOME MODELS)
Very Low
The Produce Preserver comes with a status
Very Low
indicator, which should be activated and
Very Low installed at the same time the pouch is
installed.
Very Low
Very High
Very Low
1.
Place the indicator face-down on a firm, flat
surface.
2.
Apply pressure to the bubble on the back
of the indicator until the bubble pops to
activate the indicator.
3.
Slide open the cap on the Produce
Preserver housing.
4.
Place the indicator in the top of the
housing facing outward.
5.
Slide the cap closed, and check that the
indicator is visible through the rectangular
hole in the cap..
NOTE: The cap will not easily close if the
indicator's rear bubble has not been
popped.