Refrigerator Use; Power On/Off Switch - Jennair W10779525B Guide D'utilisation Et D'entretien

GETTING STARTED

REFRIGERATOR USE

If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similar qualified person. Do not use a
cord that shows cracks or abrasion damage
along its length or at either the plug or
connection end.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, re, or electrical shock.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such
as gasoline, away from refrigerator.
Failure to do so can result in death,
explosion, or fire.

POWER ON/OFF SWITCH

If you need to turn the power to your
refrigerator On or Off, you must remove the top
grille assembly to access the power switch. Turn
the power to the refrigerator Off when cleaning
your refrigerator.
INTEGRATED INSTALLATION - FULL HEIGHT /
ARMOIRE MACHINE COMPARTMENT COVER
To install the grille panel to the refrigerator:
1.
Slide the upper and lower slots in each
bracket onto the mounting pins extending
upward from the top of the refrigerator.
2.
Push the grille panel forward to fully
engage the spring clips and fasten the
grille panel.
TO REMOVE THE GRILLE PANEL FROM THE
REFRIGERATOR:
1.
Open the door(s).
2.
Place both hands under the grille panel,
grasping the bottom edge between your
fingers and thumbs.
3.
Pull the grille panel straight out until the
grille stops. Then, lift up on the grille panel
to remove.
TURN POWER ON OR OFF:
1.
Remove the top grille panel.
2.
Press Power switch to the ON or OFF
position.
3.
Replace top grille.
IMPORTANT: Be sure the power switch is set to
the ON position after cleaning refrigerator or
changing light bulbs.
A. Power switch
GETTING STARTED | 15
A