Install Anti-Tip Boards - Jennair JBSFS42NMX Mode D'emploi

NOTE: Pass the dolly strap under the handles.
2. Place pieces of the shipping carton on the floor when
rolling the dolly and refrigerator into the house. Move
the refrigerator close to the built-in opening.
3. Place top of cardboard carton or plywood under
refrigerator.
4. Stand the refrigerator up. First, place the left bottom
edge of the refrigerator on the floor, stand the
refrigerator upright and then lower the right-hand
side of the refrigerator to the floor.
5. Reassemble the trim and top grille after the dolly has
been removed from the refrigerator.

INSTALL ANTI-TIP BOARDS

IMPORTANT:
To avoid tipping during use, the solid soffit must be
within 1" (2.5 cm) maximum above the refrigerator. If
the solid soffit is higher than 1" (2.5 cm) or one is not
available, then the refrigerator must be braced.
It is recommended that board(s) be installed before
the refrigerator is installed.
Board(s) must be long enough to fully cover the
width of the compressor cover.
Locate the board(s) so the bottom surface(s) of the
board(s) is (are) 84" (213 cm) from the floor.
During installation, raise the refrigerator up so there
is 1/4" (6.35 mm) maximum between the top of the
refrigerator and the bottom of the anti-tip board(s).
Do not crush the compressor cover when raising the
rear leveling legs.
NOTE: The foam gasket, on top of the compressor
cover, will compress to fit under the anti-tip board(s).
There is no need to trim the gasket.
To Install Anti-tip Boards
1. Mark the stud locations on rear wall.
2. Securely attach two 2" x 4" x 32" (5 cm x 10 cm x 81 cm)
boards to wall studs behind refrigerator. Use six
#8 x 3" (7.6 cm) (or longer) wood screws. The wood
screws must be screwed into the studs at least
1½" (3.8 cm). The boards must overlap the compressor
cover.
2" (5 cm)
2" (5 cm)
D
A. Center board 1/4" (6.35 mm)
maximum above refrigerator
B. Two 2" x 4" x 32"
(5 cm x 10 cm x 81 cm) boards
SECONDARY ANTI-TIP BOARD
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Install secondary anti-tip board to ensure product
stability.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT:
For all panel installations, the secondary anti-tip
board is required to be installed prior to door panel
installation.
This anti-tip board is to be secured on the right side of
the cabinet enclosure as per the dimensions shown
in illustration.
NOTE: Anti-tip board is required as an addition
to the rear wall anti-tip board (for open to ceiling
installation) described in "Install Anti-Tip Boards"
section.
A B
C
C. Attach to studs with six
#8 x 3" (7.6 cm) screws
D. Compressor cover
20