Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Take out packaging and clean the cabinet using warm water with a 5% concentration of neutral soap.
Be sure to use a soft cloth for drying. Use only specific products for the glasses avoiding water which
can leave calcareous residues.
Always keep the cabinet a distance of at least 10 cm. from
the wall. Please settle the adjustable feet (if present) lower
or upper than the level surface of small rollers.
Cabinet must be installed on a perfectly even surface, far
away from any heat source including sun rays. It is very
important that the grills at the base are kept uncovered. Do
not install the unit in open places and do not expose it to
rain.
Never use electrical equipment in the refrigerated
compartment
Never place containers of liquid on or immediately above
the ticket counter; should the content spill out, it would
damage the counter.
Install and position the unit in such a way so as to allow
easy access to the power socket.
THE REFRIGERATOR IS NOT SUITABLE FOR
WORKING IN A DANGEROUS ENVIRONMENT
WITH RISK OF FIRE, EXPLOSIONS OR RADIATION.
Operation is regular with ambient temperature indicated on the technical data plate.
During transports operation put the wood part under the door in order to avoid possible door-frame
foldings.
INFORMATION ABOUT USE
PUTTING INTO OPERATION
Check that the voltage on the identification plate is the same
as that of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE
REFRIGERATOR WILL HAVE TO BE CONNECTED
IS TO BE PROTECTED BY A VERY SENSITIVE
DIFFERENTIAL SWITCH (Rc=16A,Dc=30mA); IT IS
ALSO TO BE LINKED TO THE GENERAL EARTHING
PLANT.
Earthing is necessary and compulsory by law. Absolutely
never use reduction units, patch cords, adapters or
multiple socket outlets to connect the counter.
DIRECTLY connect the equipment to the mains.
The manufacturer disclaims all responsability for any damage
to people or things due to incorrect observance of this rule.
-6-
10 cm
Publicité
Table des Matières
