Table des Matières
Publicité
UNPACKING
Cut the strap and lift up the cardboard package
INSTALLATION
Clean the cabinet using warm water with a 5% concentration of neutral
soap. Be sure to use a soft cloth for drying.
a distance of at least 10 cm. from the wall. Please settle the
adjustable feet(if present) lower or upper than the level surface
of small rollers.
Cabinet must be installed on a perfectly even surface, far away
from any heat source including sun rays. It is very important that
the grills at the base are kept uncovered. Do not install the unit
in open places and do not expose it to rain.
Never use electrical equipment in the refrigerated
compartment. Never place containers of liquid on or
immediately above the ticket counter; should the content
spill out, it would damage the counter.
Install and position the unit in such a way so as to allow easy
access to the power socket.
THE REFRIGERATOR IS NOT SUITABLE FOR
WORKING IN A DANGEROUS ENVIRONMENT WITH
RISK OF FIRE, EXPLOSIONS OR RADIATION.
Operation is regular with ambient temperature indicated on
the technical data plate.
During transports operation put the wood part
under the door in order to avoid possible door-
frame foldings.
INFORMATION ABOUT USE
Always keep the cabinet
PUTTING INTO OPERATION
Check that the voltage on the identification plate is the same
as that of the network. THE ELECTRICAL SUPPLY
LINE TO WHICH THE REFRIGERATOR WILL
HAVE TO BE CONNECTED IS TO BE PROTECTED
BY A VERY SENSITIVE DIFFERENTIAL SWITCH
(Rc=16A,Dc=30mA); IT IS ALSO TO BE LINKED TO
THE GENERAL EARTHING PLANT.
Earthing is necessary and compulsory by law. Absolutely
never use reduction units, patch cords, adapters or
multiple socket outlets to connect the counter.
DIRECTLY connect the equipment to the mains.
The manufacturer disclaims all responsability for any
damage to people or things due to incorrect observance of
this rule.
- 6 -
10 cm
Publicité
Table des Matières
