• The display shows the coffee strength by lighting up the symbols of beans.
• Press the aroma button (3) to either confirm or to change the aroma strength
(number of beans will change. See chapter 3.2).
• Your coffee machine is now ready for operation.
TIP:
Hold a receptacle under the output in order to collect the water.
Filling the system
Since the machine is new from the factory, it is possible that the water pipes in the
coffee machine are not filled with water when you use it for the first time. In this case,
it will be indicated as follows:
• After the machine is turned on with the on / off switch (10) the symbol
up.
• Open the steam / hot water dial (6) by turning it clockwise. The system will now be
filled and some water could drip out of the coffee outlet (8) or the jet (7).
• As soon as the filling action has stopped automatically, turn the dial (6) counter-
clockwise to turn it off.
• The symbol
• Then proceed as previously described under "2.2".
• Your coffee machine is now ready for operation.
2.3 Setting the fineness of the coffee mill
Please note:
Adjust the fineness setting only when the coffee mill is in operation.
You can adjust the degree of coarseness in the milling work for the way your coffee
beans have been roasted. We recommend, however, that you leave the coffee mill at
the medium setting.
• Move the milling level adjuster (20) to the desired position with the mill running.
The smaller the point, the finer the coffee is ground. Please note:
– Light roasted beans require a fine setting
– Dark roasted beans require a coarse setting
3. Preparation
Please note:
☛
The coffee machine was set at the factory so that you could make your first
cup of coffee immediately. However, we recommend that you program the
most important basic settings according to your needs. Therefore, you should
first carry out the steps of the water hardness and the temperature settings
mentioned in chapter "4. Programming".
13_1383_ROT_BA_AdaVero_IH.indd 21
13_1383_ROT_BA_AdaVero_IH.indd 21
lights up.
will light
21
06.01.14 10:23
06.01.14 10:23