Programming; Filter - Rotel Adagio Mode D'emploi

Masquer les pouces Voir aussi pour Adagio:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. Programming

The following buttons are used for programming:
Coffee button (4)
Steam / rinsing button (5)
You can reprogram the following settings:
Filter / Water hardness / Automatic switch-off time / Temperature / Rinsing at
switch-off
If the programming is interrupted for longer than 1 minute, the machine reverts
automatically to the coffee ready mode.

4.1 Filter

For all of our coffee machines you can buy from us a special filter for the water tank as
an accessory. With the correct use of this filter, you will not have to descale your coffee
machine as often. In order for the appliance to know that the filter has been installed,
you must program the filter setting to "Yes". The factory setting is without filter.
If you use the filter in your machine and you have programmed the system to
"Yes", the water hardness will automatically be programmed to level 1.
The effectiveness of the filter will be exhausted after drawing approx. 50 liters
of water. The Symbol
changed (see chapter 5.1)
Please note: If your use of water is lower, the filter must be replaced after two
months at the latest.
Operating the appliance with filter:
• Drain the water tank (11) and screw the filter into the filter holder (18) using the
enclosed mounting tool (17).
• At the date ring (months) at the top end of the filter cartridge, set the installation
and replacement date.
• Fill the tank with fresh water and reinsert the tank in the machine.
• To access the basic settings menu hold the steam / rinsing button (5) more than 3
sec. until the symbol
• Press the coffee button (4) several times until the symbol
symbol
.
• Press the steam / rinsing button (5) to confirm.
• In the display the symbol is blinking and the symbol
TIP:
Place a sufficiently large receptacle (approx. 0.5 l) under the jet (7).
• Turn the steam / hot water dial (6) to the right. The system is being rinsed through
the jet and the symbol is blinking.
• Wait until no more water comes out of the jet and the symbol
• Close the steam / hot water dial (6) by turning it to the left. The display shows the
coffee beans and the machine is ready for service.
13_1383_ROT_BA_AdaVero_IH.indd 25
13_1383_ROT_BA_AdaVero_IH.indd 25
will appear in the display when the filter has to be
and 3 bars light up.
appears next to the
lights up.
lights up.
25
06.01.14 10:23
06.01.14 10:23

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

VeronaU27.32chU27.30ch

Table des Matières