Using Your Coffee Machine For The First Time; Filling The System; Setting The Fineness Of The Coffee Mill - Rotel Adagio Mode D'emploi

310032 rotel_adagio U2732_U2733_inhalt.qxp:Rotel_Adagio277_Content
Use only clear cold water when filling the tank, and never use carbonated
water or other liquids.
• Open the cover to the bean holder (11) and fill it with coffee beans.
Never use beans which have been treated with additives, such as sugar, dur-
ing or after roasting. This can damage the milling mechanism, and any such
damage is not covered under the guarantee.
• Please make sure that the steam/hot water dial (7) is set to O.

2.2 Using your coffee machine for the first time

• Pull the power cord from the cord compartment (14) and plug it in.
• Switch on the power switch (13).
• The symbols
• After the coffee machine has heated up, the steam/rinsing button (6) will begin to
blink.
• Press the steam/rinsing button (6) and the system is rinsed through the coffee outlet (9).
• Then all operator buttons (3/4/5/6) light up continuously and in the display the
selected coffee strength is indicated by the lighting up of the appropriate number of
beans.
• Your coffee machine is now ready for operation.
TIP: Hold a receptacle under the output in order to collect the water.

Filling the system

Since the machine is fresh from the factory, it is possible that the water lines in the
coffee machine are not filled with water when you use it for the first time. In this case,
it will be indicated as follows:
• After the machine is turned on with the on/off button (13) the
• Open the steam/hot water dial (7) by turning it clockwise. The system will now be
filled and some water could drip out of the jet (8).
• As soon as the
automatically, turn the dial (7) counterclockwise to turn it off.
• Then proceed as previously described under «2.2 Placing in operation».
• Your coffee machine is now ready for operation.

2.3 Setting the fineness of the coffee mill

Please note: Adjust the fineness setting only when the coffee mill is in operation.
You can adjust the degree of coarseness in the milling work for the way your coffee
beans have been roasted. We recommend, however, that you leave the coffee mill at
the medium setting.
• Move the milling level adjuster the back (12) to the desired position with the mill run-
ning. The smaller the smaller the point, the finer the coffee is ground. Please note:
– Light roasted beans require a fine setting.
– Dark roasted beans require a coarse setting.
, and will light up one after another .
symbol lights up constantly and the filling action has stopped
17.1.2011 14:09 Uhr
symbol begins to blink.
25
Sei