General Information - SATA air check set Mode D'emploi

Operating instructions SATA air check set
Content [Original Version: German]
1.

General information ...............25

2. Safety Instructions .................26
3. Intended Use .........................28
4. Description ............................28
5. Scope of Delivery ..................28
6. Technical Design ...................28
7. Technical data .......................28
Read these operating instructions thoroughly and carefully before com-
missioning and use. Comply with the safety instructions and danger
warnings!
Always make sure that these operating instructions are kept with the
product or keep them easily accessible for everyone at any time!
1. General information
1.1. Introduction
These operating instructions contain important information for operating
the SATA air check set, referred to hereinafter as air check set. They also
describe how to check the test membrane, together with care and storage
instructions.
1.2. Target group
This operating manual is intended for
■ Painting and varnishing professionals.
■ Trained personnel for varnishing work in industrial and craftman's work-
shops.
1.3. Accident prevention
As a basic principle, the general and specific national accident prevention
regulations must be heeded, together with corresponding workshop and
industrial safety instructions.
1.4. Accessories, spare and wear parts
Always only use original SATA accessories, spare parts and wear parts.
Accessories not supplied by SATA have not been tested and approved.
SATA assumes no liability for damage caused by the use of non-approved
spare parts, accessories and wear parts.
Read first!
8. Test procedure .......................29
9. Care and storage ...................31
10. Disposal .................................32
11. After Sales Service ................32
12. Spare Parts ...........................32
13. EU Declaration of
Conformity .............................32
EN
25