Publicité
3.2 CLEANING
•
Clean the device thoroughly after each use.
•
Before cleaning the device, disconnect it from the power source (unplug it) and wait until it reaches room
temperature.
•
Open the cover and remove the waste bucket.
Wipe the device with a damp cloth, preventing liquid from entering the controllers
•
Clean the inside and outside of the unit, the door and the gasket with a damp cloth and an acid-free cleaning
•
agent.
Dry all cleaned surfaces thoroughly.
•
•
Always use a soft cloth and do not use abrasive cloths that may scratch the unit and equipment.
•
Dry the washed parts with a dry cloth.
•
Leave the door open for a while for the interior to dry completely.-If necessary, the door gasket should be
removed and cleaned.
3.3 COMMISSIONING
•
Before operating the device, wipe the interior with a damp cloth and then dry it.
Plug the electrical plug into a socket with earth contact installed in accordance with the regulations. The
•
mains voltage must comply with the value data on the type label.
Turn on the main switch. The digital thermostat shows the current temperature in the cooling cabinet and
•
the circulation fan operates continuously. The device should be operated until it reaches the factory
temperature setting.
•
Only internally mounted ramps and garbage bins for waste disposal coolers can be disassembled and
installed for easy replacement.
Make sure that the air inlet and outlet are open. In order for the cooling device to work properly, the above-
•
mentioned warnings must be followed and the device must be clear of obstacles.
If the device will not be used for a long time, you must unplug it. To prevent the formation of odor in the
•
uncooled interior, care should be taken to leave the covers and doors open.
•
NOTE: When you commission the device;
•
If the device does not cool: Look at the digital screen of the device, are there any indicators ?
•
Check whether the electrical plug of the device is properly inserted into the socket?
•
Make sure whether there is voltage in the mains socket?
•
Does the cover and door of the device not have to be opened frequently or filled excessively for cooling?
•
Check whether the device cover or door is closed properly ?
Check whether the device door gasket is seated correctly.
•
3.4 MAINTENANCE AND SAFETY INSTRUCTION
Installation, maintenance and repair work can be done by experts authorized by the manufacturer.
•
Improper installation, maintenance work or repairs are the responsibility of the user and not the
manufacturer.
•
Check the power cable regularly for damage. If the cable is damaged, do not use the device. If the power
cable is damaged, have it replaced by an authorized service.
•
In case of damage or malfunction, please contact your dealer or customer representative.
Repair and maintenance of the device should only be carried out by authorized persons using original spare
•
parts and accessories.
Note: Do not try to repair the device yourself.
•
www.combisteel.com
7
Publicité
