Publicité
•
The refrigerant for this device contains propane (R290). Propane is a colorless flammable gas. It has a low
global warming potential. It has no ozone depletion potential and replaces R12, R22, R134 and others.
•
Make sure that no part of the cooling device is damaged when installing and transporting the device.
•
In addition to the operating noise of the compressor, flow sounds can also be heard in the entire cooling
circuit. Unfortunately, these effects are inevitable but have no impact on the performance of the device.
The device should not be connected to the mains via extension cables or socket bars. These do not provide
•
the necessary safety and may pose a risk of overheating .
•
The manufacturer cannot be held responsible for any damage caused by the missing or broken grounding
conductor , such as electric shock.
•
The electrical safety of the device is only guaranteed if it is connected to a protective earthing system
installed in accordance with the regulations. It is important that this basic and technical safety requirement
is met.
2. TRANSPORTATION PACKAGING AND STORAGE
2.1 DELIVERY CONTROL
Please check the delivery for completeness and shipping damage upon receipt. Report any visible damage.
Report the extent of damage along with the carrier's delivery invoice.
2.2 PACKAGING
Before installation, completely remove the outer and inner packaging material from the unit. When disposing
of the packaging, comply with the regulations applicable in your country. Recycle reusable packaging materials.
Please check whether the device is complete and if any part is missing, contact our customer representative
immediately.
2.3 STORAGE
Keep the packaging closed until installation, in accordance with the installation and storage markings on the
outside. The following notes should be taken into consideration when storing the packages. -Do not store
outdoors. -Keep it in a dry and dust-free place. -Do not allow contact with corrosive substances and do not
expose to direct sunlight. -In case of long-term storage ( > 3 months) Check the condition of the packaging and
parts regularly.
3.CLEANING WASTE AND MAINTENANCE
3.1 SAFETY INSTRUCTION
•
Do not use acidic substances and be careful not to let water enter the device.
To protect against electric shock, prevent the unit, its cables or plug from coming into contact with water
•
or other plasters.
The device is not suitable for direct cleaning with pressurized water. Therefore, do not use pressurized water
•
to clean the equipment !
www.combisteel.com
6
Publicité
