Blade Adjustment; Transportation; Troubleshooting Guide - Altrad Belle PRO 600X Manuel De L'opérateur

Table des Matières

The blade pitch control knob is at easy reach of the operator. The pitch adjustment has an unlimited pitch variation and this can

be undertaken whenever necessary. During ﬁ nishing setting up/hardening may vary from area to area across the ﬂ oor, so the pitch

adjustment can be changed to suit accordingly while the machine is in operation. When transporting the trowel on a truck, always

keep blades fully horizontal ﬂ at on the ﬂ oating disc.

For transportation of the machine use lifting eye. Alternatively to lift the machine, use an aid equipment through the stationary ring, which

can carry the weight of the machine ,with a carrying pipe on the back past of handle.

Problem

Cause

Engine will not start.

No fuel getting to engine.

Engine switched off.

Spark plug fouled.

Engine cold.

Engine ﬂ ooded.

Cutout switch wire

Leaving Swirls in

Main Shaft damaged.

concrete, Rolling

Spider Plate arms bent.

Concrete or Bouncing.

Blades are unevenly adjusted.

Blades are all different sizes.

Blades are worn.

Gearbox

Check oil level every month. On side of the gearbox there is an plug. Use "SHELL OMALA 220 (750ml)" gear oil or equivalent.

Machine Cleaning

Clean the machine after it has been used to prevent the collection of hardened cement. Hard concrete/cement paste is very difﬁ cult

to remove. To clean it use an old brush or hand brush.

Changing of Blades

Be careful when changing old blades with new. Due to the way the blades wear, the old blades become very sharp, like a knife

blade. As a safety precaution very heavy-duty gloves during this operation to prevent the hands being cut. Remove bolts and lock

washers on each trowel arm and remove the blades. Before installing new blades clean all concrete/cement from bottom and side

of the trowel, be sure trowelling edge of the blade is behind trowel arm. Install bolts and lock washers on each trowel arm and

fasten securely.

Tightening the V-Belts

If you notice a loose on V belt, check the tightness. Especially in ﬁ rst using and V belt change. Check the V belt tightness after 8

hours later. Using your head ﬁ nger push the V belt from its middle point. It must stretch about 2cm.If it stretches more, it is loose.

For tightening; loose the motor ﬁ xing screws.(till motor moves away on the table) Loose the motor lock nut. Loose the screws, push

the motor backward. Checking the V belt tightness, do the same operations. Until tightness of V belt is desired value, screw the

motor luck nut, and then screw the motor ﬁ xing screws.