Pre-Start Checks; Operating Instructions; Environment - Altrad Belle PRO 600X Manuel De L'opérateur

Pre start-up inspection.
The following Pre-start-up inspection must be performed before the start of each work session or after every four hours of use, which-
ever is fi rst. Please refer to the service section for detailed guidance. If any fault is discovered, the Pro 600X must not be used until
the fault is rectifi ed.
1. Thoroughly inspect the Pro 600X for signs of damage. Check components are present and secure. Pay special attention to the
Drive Belt safety guard fi tted between the engine and gearbox unit.
2. Check fl uid lines, hoses fi ller openings, drain plugs and any other areas for signs of leakage. Fix any leaks before operating.
3. Check the engine oil level and top up as necessary.
4. Check the engine fuel level and top up as necessary.
5. Check for fuel and oil leaks.
Before you operate or carry out any maintenance on this machine YOU MUST READ and STUDY
WARNING
this manual.
Starting Procedure
- Be sure the fuel tank is full. Use the recommended fuel to runt he engine
from its instruction booklet
- Check engine oil levels
- Turn the engines stop switch clockwise to the position 'I'.
- Open the fuel cock.
- Set the speed control lever 1/3 of the way towards the high speed
position.
- If the engine is warm of the ambient temperature is high, close the
choke lever half way, or keep it open fully. If the engine is cold, or the
ambient temperature is low, close the choke lever.
- Pull the starter handle slowly until the resistence is felt. Return the
handle to its original position and pull swiftly.
- Allow a longer warm up period in colder temperatures.
Operation
- Guiding the trowel on the slab is very simple. Get into the operator's
position behing the centre of the handle, attain a good footing and apply
the throttle slowly until desired speed is obtained. (A)
- Push handle down and machine will move to the right (B). lift the handle up and the machine will move to the left (C)
- Slightly twist to the left and the machine will move to the left. The machine will remain stationary if you do not apply any force up
or down.
Stopping the engine
- Never use the choke to stop the engine. Leave the machine run at an idle speed for 2-3 minutes to cool down .
- Move the Gas lever to minimum throttle. Turn the button, which is on the gasoline engine, to the OFF position to stop the machine
lastly.
(Note: The illustration above is of the Pro 900, but the instructions are correct for the Pro 600X)
Safe Disposal.
Instructions for the protection of the environment.
The machine contains valuable materials. Take the discarded
apparatus and accessories to the relevant recycling facilities.

Pre-start Checks

Operating Instructions

Environment

13
Component Material.
Handle Steel
Belt Guard ABS
Bedplate Steel
Hand Grips Rubber
Engine Aluminium and Steel
Motor Steel and Copper
Gearbox Aluminium, Steel and
Phosphor Bronze
Various Parts Steel and Aluminium