Pre-Start Checks; Operation - Altrad Belle MEGAVIB+ Manuel De L'opérateur

machine.
ENSURE that all housing screws are tight before starting work.
AVOID
DO NOT CONNECT
DO NOT OPERATE the motor when this is working and without transmission.
DO NOT WORK
DO NOT WORK with the plastic housing broken.
DO NOT PERMIT untrained personnel to operate the motor or connections.
MAINTAIN free ventilation of air.
KEEP the motor in a clean and dry area.
MAKE SURE that the electrical cable is with the proper section and functioning properly.
BEFORE DOING
WHEN CONNECTING
WHEN FINISHING
placed in such a way that it should not fall or tip.
In addition, all local regulations should be respected.
Vibration
PPE (Personal Protective Equipment).
Should be used because the acoustic power level of this machine is 92 dB and the acoustic pressure level is 86 dB.
proper responsible person immediately.
Shaft Connection To Power Unit
Connection Procedure:
1. Face the male hexagon of the transmission in the female hexagon of the motor.
2. Once faced the hexagons push until making that the anchorage of the transmission enters in the special lodging of the motor.
Connection possibilities
Electric Motor Connection To The System
Electrical Connection
ensure it corresponds to the voltageas indicated on the rating label.
230v
115v - When using a portable transformer it must have a minimum output of 2.5kw and to be continuous rated.
Extension Cables
2
must be 1.5mm
CAUTION
make sure that the voltage and frequency match with the ones stated on
DISCONNECT the motor from the electrical system.
make sure

Pre-Start Checks

Do not use damaged or worn out cables.
Do avoid heavy loads on top of cables.
make sure that operators have been instructed in the correct use of this

Operation

17
GB
GB
GB