Publicité
All manuals and user guides at all-guides.com
TV EXPLORER HD / HD
USER'S MANUAL.
During analogue channel measuring process, a percentage counter appears at the
bottom of the screen showing the percentage of channel measurement done. In the case
of digital channels, appears a timer showing time left to finish in seconds. At the top left
corner appears the channel being measured followed by the total amount of channels in
the current channel plan.
In order to select a field on the datalogger screen (Test point and datalogger
name), press the arrow
[1].
After selecting the
measurements automatically. Once completed, the process will be ready to repeat again
START
(
) (for example, for a new test point), or view measured data by selecting the
channel and turning the rotary selector
SAVE
(
) or exit from this acquisition (
5.10.1 Datalogger for Attenuation and IF SAT tests
TV EXPLORER
The
executing an Attenuation test at terrestrial band or an IF SAT test at satellite band (see
section "5.11 Verification of distribution networks").
For it, one of these tests should be activated previously as the following figure
shows.
10/2012
LE
Figure 12.- DATALOGGER
[6] key and then edit it by pressing the rotary selector
START
field the instrument begins to carry out the available
[1], or store the information in memory
EXIT
).
HD
/
HD
allows to make measurement acquisitions while
LE
screen.
Page 37
Publicité
