Publicité
All manuals and user guides at all-guides.com
Use key
[17] to switch between analogue and digital channels. Press the
[17] key to show the
Signal
option by turning and pressing the rotary selector
allows setting the type of signal to measure. When switching to a new type, the
TV EXPLORER
HD
/
HD
type of signal.
5.7
External Units Power Supply
TV EXPLORER
The
external units (antenna preamplifiers, in the case of terrestrial TV, LNB in the case of
satellite TV, or IF simulators).
In order to select the supply voltage of the external units, press
the screen will display a functions menu labelled
voltages (which will depend on the band being used). Turn the rotary selector
the desired voltage and press to activate it. The following table shows the choice of
supply voltages:
Band
SATELLITE
TERRESTRIAL
MATV
(Master Antenna Television)
Page 32
USER'S MANUAL.
measurements CONFIGURATION
activates the last measurement configuration used for that
LE
HD
/
HD
can supply the voltage needed to power the
LE
Powering voltages
Output: Enabled / Disabled
External
5 V
13 V
15 V
18 V
24 V
13 V + 22 kHz
18 V + 22 kHz
Output: Enabled / Disabled
External
5 V
13 V
15 V
18 V
24 V
Table 3.-
External units powering voltages.
TV EXPLORER HD / HD
menu and select the
Signal
[1]. The
[11] key, and
EXT. SUPPLY
listing the choice of
LE
option
[1] to
10/2012
Publicité
