Sony SU-WL450 Informations D'installation page 17

3
Preventing the bottom of the TV
or LCD Monitor from shifting.
• Take up the slack of Belt  and attach it
to the wall tightly.
2-a
 Belt
• Use a 5 mm diameter screw or equivalent
(not supplied).
Note
 Try to pull the bottom of the TV or LCD Monitor
towards yourself slightly, to make sure that it does
not move forward. If there is any movement, it is
not fixed correctly, and the Belt  should be
secured firmly again.
Confirming the Completion of
the Installation
Check the following points.
 The Pulleys  are firmly hung onto the Base
(20)  or Base Adapter .
 The cord and the cable are not twisted or
pinched.
 The Belt  is tight with no slack.
WARNING
 Improper placement of the AC power cord (mains lead),
etc. may cause fire or electric shock through a short
circuit. Be sure to confirm the completion of the
installation for safety.
Other Information
When removing the TV or LCD Monitor, reverse
the previous installation procedure.
2-b
 Belt
WARNING
 Two or more persons (three or more persons for
189.3 cm (75 inches) and above TV or LCD Monitor) are
needed to transport a large TV or LCD Monitor (except
Egypt).
Two or more persons (three or more persons for
75 inches (189.3 cm) and above TV or LCD Monitor) are
needed to transport a large TV or LCD Monitor (Egypt
only).
Specifications
g
Dimensions: (Approx.) [mm]
a : 400
b : 300
c : 200
d : 100
e : 80
f : 480
g : 100
h1 : 20 (for slim mounting, 2-b)
h2 : 60 (for standard mounting, 2-a)
Mass (base only): (Approx.) [kg]
0.8
Design and specifications are subject to change without
notice.
− 16 (EN) −
f h1 h2
e
d
c
b
a