Sony SU-WL450 Informations D'installation page 12

5
Connect the necessary cable(s)
to the TV or LCD Monitor.
Make sure to connect the cables before
installing the TV or LCD Monitor on the wall.
You will be unable to connect the cables
when the TV or LCD Monitor is installed.
Note
 Subcontract the cable routing in the wall to a
licensed contractor.
 Bundle the connecting cables to prevent stepping
on them before wall mounting.
6
Detach the Table-Top Stand from
the TV or LCD Monitor.
Note
 Be careful when lifting the TV or LCD Monitor as
the Table-Top Stand is detached, the Table-Top
Stand may topple over and cause personal injury.
 Take care when removing the Table-Top Stand from
the TV or LCD Monitor to prevent it from falling
over and damaging the surface that the TV or LCD
Monitor is sitting on.
Installing the TV or LCD
Monitor on the Wall
K-85XR9x / 75XR9x,
Y-85XR9x / 75XR9x only
WARNING
 Two or more persons (three or more persons for
189.3 cm (75 inches) and above TV or LCD Monitor) are
needed to transport a large TV or LCD Monitor (except
Egypt).
Two or more persons (three or more persons for
75 inches (189.3 cm) and above TV or LCD Monitor) are
needed to transport a large TV or LCD Monitor (Egypt
only).
1
Lift the TV or LCD Monitor.
• For the location of the Pulleys  to hang
on the Base (20)  or Base Adapter ,
refer to "Base Adapter  fitting location"
on page 17.
• Make sure that the rear of the TV or LCD
Monitor touches the Base (20)  or Base
Adapter  when holding the TV or LCD
Monitor.
Note
 Hold the TV or LCD Monitor securely with both
hands and make sure the Belt  and the bottom
of the TV or LCD Monitor align with the masking
tape.
− 11 (EN) −
EN