Scheppach HS720 Traduction Des Instructions D'origine page 30

14. Handling the protection cage
• Open the protective cover (1).
• Insert the material to be cut.
• Close the protective cover (1).
• Swivel the rocking frame (2) with hand grip (A) or (B) to the saw blade and saw through the material to be cut.
• Swivel the rocking frame (2) back and open the protective cover.
• Add more material to be cut and close the protective cover again.
1
2
15. Sawing operation
1. After the machine has been switched on, wait until
the saw blade has reached full speed.
2. Place the wood in the swivel frame.
3. Hold the handle of the swivel frame with both
hands and guide it evenly towards the saw blade.
4. Only apply enough pressure on the swivel frame
when sawing so that the speed of the saw blade
does not drop.
5. Remove the sawn wood from the swivel frame af-
ter it has returned to its original position and the
saw blade is covered. Now place the next piece
of wood on.
m Attention!
• Do not leave the machine unattended during op-
eration.
• Switch the machine off, remove the mains plug or
close the fuel valve when stopping work.
Work complete
• Switch off the drive motor with the On/Off switch.
• Wait until the saw blade has come to a complete
stop.
• Pull out the mains plug or close the fuel valve.
• Observe the general maintenance information.
• Bring the swivel frame to the transport position and
secure it with the swivel frame lock.
30 | GB
B
A
16. Maintenance and service
m Only carry out maintenance, modification,
adjustment and cleaning work when the engine
is switched off and the mains plug connector is
disconnected or the fuel valve is closed.
• Keep the instructions with the machine.
• Keep the machine clean.
• Wear safety goggles when cleaning.
• Attention! Danger of fire due to chips in the event
the cleaning carried out is insufficient.
Before starting the maintenance or checks, clean
the work area and have suitable tools at hand and in
good condition.
The time intervals relate to normal operating condi-
tions. If the machine is subjected to heavier loads,
these times must be reduced accordingly.
Clean the machine cladding, panels and control
levers with a soft, dry cloth or a cloth that has been
slightly moistened with neutral cleaning agent. Do
not use any solvents such as alcohol or petrol as
these may damage the surfaces.
Keep oils and lubricants out of reach of unauthorised
persons. Read through the instructions on the con-
tainers carefully and follow them closely. Avoid direct
contact with the skin and wash off thoroughly after
use.
m Check all safety devices after all maintenance
or cleaning work.
www.scheppach.com
1
2