Scheppach HS720 Traduction Des Instructions D'origine page 24

• Never refuel the device in enclosed spaces.
• Before switching on the engine, you must clean the
tank and the device of petrol residues.
• Heated petrol expands. Do not fill the fuel tank to
the brim, but leave some space so that warm petrol
can expand.
• The fuel cap has a ventilation slot for the escape of
fuel vapours.
• Always use an original tank cover.
• Failure to observe the petrol safety instructions can
trigger fires and explosions, it can cause serious
injuries and damage the device and other people's
property.
• Filling petrol into a running or hot engine can trigger
an explosion.
• Before refilling with petrol, always switch off the en-
gine and let it cool down for a few minutes.
• Remove wood chippings and other debris from the
device. Keep the device clean to increase its per-
formance.
• The engine, transmission and exhaust get very hot
in a few minutes when the engine is running. Do
not touch these parts of the device under any cir-
cumstances.
• Before servicing the device, you must first switch
off the engine and allow the engine and transmis-
sion to cool down.
• Remember, exhaust fumes are dangerous. Never
switch on the device in enclosed spaces.
• Dispose of used engine oil in accordance with local
regulations.
• Switch off the engine immediately if you notice any
unusual noises or vibrations.
• Unusual noises or vibrations are usually warnings
of major problems.
24 | GB
5. m Residual risks
The machine has been built according to the
state-of-the-art and the recognised technical
safety requirements. However, individual resid-
ual risks can arise during operation.
• Danger of injury for fingers and hands due to the
rotating saw blade with improper guiding of the
workpiece.
• Risk to health from wood dust or wood chippings.
The type of wood and degree of drying has an influ-
ence on the exposure to dust. Use a chip extraction
system if necessary.
• Wearing personal protective equipment such as
protective goggles and dust masks is mandatory.
• Risk to health due to noise. The permissible noise
level is exceeded during operations. It is essential
that personal protective equipment, such as hear-
ing protection, is worn.
• Hazard due to electrical power, with the use of im-
proper electrical connection cables.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "safety in-
structions" and the "Proper use" are observed
along with the whole of the operating instructions.
• Injuries due to defective saw blade. Check the in-
tegrity of the saw blade regularly and before each
use.
• When using special accessories, the operating in-
structions enclosed with the special accessories
must be observed and read carefully.
• The noise emission can be reduced by using a spe-
cific saw blade.
www.scheppach.com