Publicité
Ensure that the power cable of the solar panel
solar panel
and the light is approx. 2.5 m.
16
Mounting the product
Ensure that the product is placed with the light head
any other position.
Assembly and secure the product to a stable and solid surface according to the instruction in Fig. A.
Note: The enclosed mounting material is suitable for ordinary masonry construction. Other wall
substrates may require other fastening materials. Seek specialist advice when in doubt.
After mounting, check that the product is fitted securely.
Mounting the solar cell
Ensure that the external solar panel
panel
in any other position.
16
Secure the solar panel
Note: The enclosed mounting material is suitable for ordinary masonry construction. Other wall
substrates may require other fastening materials. Seek specialist advice when in doubt.
After mounting, verify the solar cell is fitted securely.
Connecting the solar cell to the light head
After mounting the two operating units (light head
jected to mechanical stress. Use typical installation material such as cable clamps or conduit to fasten
the cable, to prevent damage to the insulation.
Connect the plug connector
Start-up
Note:
Connect the light head
also works as a twilight sensor, while the motion sensor
When selecting the setup location for the solar cell
sensor, are not affected by other light sources, e.g. street lighting.
The switch
on the light head
12
Position "OFF":
Motion sensor
batteries are charged by the solar cell
chargeable batteries (see "Charging the rechargeable batteries").
Position "ECO":
The solar cell charges the rechargeable batteries in sunlight. The light head
automatically switches on or off once the solar cell
ensure a long life the LEDs will not be fully powered in this setting, but only pro-
vide approx. 25 % of their full light power (eco mode). When fully charged, the
rechargeable batteries will provide approx. 8 hours of light in this setting.
Position "PIR":
The solar cell charges the rechargeable batteries in sunlight. The solar cell
tomatically switches the light head
sensor
If additional movement is detected during these 1.5 minutes, the light on time
will reset. In this setting the LEDs will be fully powered. With the rechargeable
is placed with the panel upwards. Do not install the solar
16
to a stable and solid surface according to the instruction in figure D.
16
from the light head cable and the solar cell (see Fig. E).
15
to the solar cell
2
1
(Fig. C) features the following functions:
2
and light head
7
detects movement. The light on time is preset to approx. 1.5 minutes.
7
can reach the light. Max. distance between the
16
upwards. Do not install the product in
2
and solar cell
) run the cable so it is not sub-
2
1
before using for the first time. The solar cell
only responds to movement.
7
be sure the solar cell, just as the twilight
1
are off. In direct sunlight the rechargeable
2
. Use this setting to charge drained re-
1
on in twilight or the dark when the motion
2
detects dusk or dawn. To
1
GB/IE/NI
1
2
au-
1
9
Publicité
