Publicité
Only use the same type of batteries / rechargeable batteries. Do not mix used and new batteries /
rechargeable batteries.
Remove batteries / rechargeable batteries if the product will not be used for a longer period.
Risk of damage of the product
Only use the specified type of battery / rechargeable battery!
Insert batteries / rechargeable batteries according to polarity marks (+) and (-) on the battery /
rechargeable battery and the product.
Clean the contacts on the battery / rechargeable battery and in the battery compartment before
inserting!
Remove exhausted batteries / rechargeable batteries from the product immediately.
Function
The solar cell
converts energy from sunlight into electricity. This recharges the rechargeable batteries
1
inside the battery compartment
These rechargeable batteries store the electricity fed by the solar cell. Fully charged rechargeable bat-
teries will provide about 2 hours of light on the "PIR" setting, and about 8 hours on "ECO". In summer
completely drained rechargeable batteries take about 2 to 4 days to fully recharge in constant sunlight.
The rechargeable batteries must be charged prior to initial use (see "Charging the rechargeable batteries").
Before use
Charging the rechargeable batteries
Note: The rechargeable batteries inside the light head
may already have lost charge during transport from the manufacturer to the retail location. Therefore
charge the rechargeable batteries prior to use. During summer, initial charging will take at least one
day in constant sunlight.
Set the switch
Note: In constant sunlight (depending on the season) drained rechargeable batteries should take
two to ten days to charge.
Note: The built-in charging controller of the product prevents the rechargeable batteries from
overcharging.
Replace the rechargeable batteries if the light output does not improve after charging (Fig. B, C).
Assembly
Select a suitable place for installation.
Ensure that the motion sensor
due to obstacles or constantly moving objects.
Ensure that the solar panel
Ensure that the solar panel
e.g. due to heating devices.
Ensure that the solar panel
direction.
Ensure that the supplied screws and wall plugs are suitable for the type of wall. If not, use other
suitable screws and wall plugs. The manufacturer is not responsible for improper use of wall
connections.
8
GB/IE/NI
via the power cable.
10
to the "OFF" position.
12
will not be functionally inhibited at the desired place of installation
7
is mounted in a place with direct sunlight.
16
is not installed where there are strong temperature fluctuations,
16
is installed far away from unnatural light sources and in southern
16
are fully charged at delivery. However, they
2
Publicité
