NOTA: Do not leave the choke in an intermediate position, the mixture would
be too rich and the engine would work incorrectly.
8. Pull softly again until you notice slight resistance, now the rope to coil back and
then pull energetically to start up the engine.
9. After starting, it is recommended to leave the generator running for a few
minutes with no load connected to allow the engine to stabilize and increase its
initial temperature progressively. Then connect the loads.
NOTE: If the rope recoils abruptly, the spring or the rope itself may be
damaged. This is not covered by the warranty. After pulling, do not release wilfully
the handle to avoid hitting the machine. Control the handle tightly until it is fully
recoiled.
65