Publicité
4.2 Assembling the transport kit
Fix the wheels according to the figure below: cross the wheel (2) with the axle (3) and then
place the washer (4) and pass the end of the axle through the hole provided in the
generator frame for this purpose. Finally fix the shaft with the pin (1)
Fix the support feet according to the image
on the right.
Fix the rubber feet (4) to the support (3)
with M6x18 screws (5) and M6 nuts (2).
Once the support has its feet mounted, fix it
to the generator structure with M8x18
screws (1).
Fix the handlebars according to the
image on the left.
Use the M8x55 screw (5) and M8 nut
(6) to fix the right handlebar (1).
Use the pin (2) and R-pin (4) to fix
the left handlebar (3).
49
Publicité
