Publicité
INSTALLATION INSTRUCTIONS
STEP 6. SECURING THE OUTDOOR UNIT
Anchor the Outdoor Unit
The outdoor unit can be anchored multiple ways* — a pad on the ground, a wall bracket, or a stand/blocks
(*not included).
WARNING
WHEN DRILLING INTO CONCRETE, EYE PROTECTION IS HIGHLY RECOMMENDED.
Installing the unit on a concrete condenser pad:
1.
Mark the positions of the four feet.
2.
Pre-drill holes for expansion bolts, clean any dust away from holes.
3.
Place a nut on the end of each expansion bolt.
4.
Hammer expansion bolts into the pre-drilled holes.
5.
Remove the nuts from expansion bolts. Place outdoor unit on bolts.
6.
Put washer on each expansion bolt, then replace the nuts.
7.
Using a wrench, tighten the nuts until snug.
Installing the unit on a wall-mounted bracket?
Please refer to the bracket manufacturer's directions for installation.
(Continued)
19
Publicité
