Publicité
INFORMATIONAL QUICK GUIDE
CHOOSING INSTALLATION LOCATIONS FOR INDOOR WALL UNITS
Before installing the indoor unit, you must choose an appropriate location. The following are standards that
will help you choose an appropriate location for the unit.
The location should also meet these standards:
• A space with good air circulation.
• A space with convenient drainage for indoor condensate (tube that will go to the outside with the
line set bundle).
• A wall strong enough to support the weight of the unit:
• A location at least 3.5 ft. (1.1 m) from all other electrical devices (e.g., TV, radio, computer)
• DO NOT install the unit in the following locations:
• Near any source of heat, steam or combustible gases.
• Near flammable items such as curtains or clothing.
• Near any obstacles that might block air circulation.
• Near a doorway or window.
• In a location in direct sunlight.
Find an area on an exterior wall, at least 6 inches (15.25 cm) from the ceiling and 4.75 inches (12 cm)
from the adjacent wall.
NOTE about the wall hole:
a wall hole to pass the communication cable and refrigerant piping (line set) that connect the indoor and
outdoor units. The default position for all piping is the right side of the indoor unit (while facing the unit).
NOTE:
The unit can only be installed on an interior wall, if a 3rd party condensate pump (sold separately)
is sourced and installed.
While choosing a location, be aware that you need to leave ample room for
(Continued)
11
Publicité
