Bimar KPT-2000B 5208LE Notice D'instructions page 22

6. Press the
shows the starting time, every time the button is pressed it
adds an hour to the shut-down time.
7. Set the temperature as explained in the previous chapter.
8. Repeat n.2 to n.7 to set the entire week, then press
9. To stop the weekly program, press the
the program is stopped. To restart the programmation press "P" again.
To verify the programmation press the
up.
Note:
there is no regulation in minutes.
The shut-down time can not be lower than the starting time.
If the starting time and the shut-down time coincide the appliance goes into stand-by.
Window sensor settings:
1. Press the
2. Press the
shows" 23" (the default temperature) press the
button to increase or decrease temperature. The lights
next to these symbols
If the temperature goes down too quikly the program switches the appliance to stand-by mode:
press the button to start the appliance. Press the
corresponding light will shut-down and the appliance works with the previous functions.
3. When both "window sensor settings" and "weekly program" are active the appliance is on
when both functions are active and is off if the functions are inactive.
To switch off the appliance, press the "
CLEANING AND MAINTENANCE
Attention: before cleaning the appliance, switch off, unplug and wait for before it has
completely cooled down.
• To clean the body use a soft damp cloth; do not use abrasive products.
• Do not submerge any part of the heater in water or other liquids; if this should happen, do not
put your hands into the liquid, firstly remove the plug from the power socket. Carefully dry the
appliance and check that all the electrical parts are dry: if in doubt, contact professionally
qualified personnel.
• From time to time clean the grid to remove fluff, dust or other deposits, to improve the
performance. Use a vacuum cleaner or a cloth.
• If you decide not to use the appliance any more, we recommend making it inoperative by
cutting the power cord (after making sure you have disconnected the plug from the socket)
and make dangerous parts harmless if children are allowed to play with them.
button to set the shut-down time, the display
button: the appliance switches on.
button to set the temperature: the display
, °C, "I"e"II" should light up.
to confirm.
button: the light next to "P" will shut down, and
/ / / buttons: the light next to "P" lights
or the
button to disable the program: the
" button, then eject the plug from the power outlet.
22