Bimar KPT-2000B 5208LE Notice D'instructions page 17

room on their own, unless constant supervision is
provided
•
WARNING: to reduce the risk of fire, keep textiles,
curtains, or any other flammable material a minimum
distance of 1 m from the air outlet
•
INSTALLATION
• After unpacking, check the integrity of the appliance; if in doubt, do not use it and contact a
qualified technician.The packaging materials (plastic bags, polystyrene, metal staples, etc.) must
not be left within reach of children, as they are potentially hazardous.
All packaging elements must be disposed of according to their raw material (see the symbol
stamped on each one) and according to the provisions of their municipality.
elements of the packaging with low weight (es: packing tape) are unmarked as are its small size
packing materials, the protective film of surfaces: therefore you have to follow the procedures for
the disposal in force in your municipality.
• Before installing the appliance, make sure that:
- the electrical system to which the appliance will be connected complies with current standards and
has cables whose cross-section is suitable for the absorbed power
- the voltage values on the nameplate correspond to those on the mains supply.Check that other
appliances with high absorption are not connected to the power line to avoid overloading and fire
hazards.In the event of incompatibility between the power socket and the appliance's plug, have the
plug replaced with a suitable model by a qualified professional, who should ensure that the cable is
appropriate for the power rating of the device.The use of adaptors or extensions is generally not
advisable; if it is necessary to use them, they must comply with safety regulations and the total
current (amperes) must not be rated lower than the maximum current of the appliance.
- There are no water, gas or power lines inside the wall
- The wall to which the appliance is to be fixed must be made of masonry and/or heat-resistant, fire-
retardant and solid material (not wood or synthetic material), flat and free of irregularities; the ceiling
must also be made of fire-retardant and heat-resistant material.
- the appliance can be installed at least 2.0m from the ground (height referred to the lower edge of
the appliance), is positioned so that it cannot suffer impacts and that the air outlet grid has a free
space of at least 100cm, and at least 40cm at the sides.If installed in a bathroom, in addition to the
height from the ground, it must be ensured that the switches and control devices cannot be touched
or reached by a person in the bathtub or shower.
- the appliance is away from other sources of heat, flammable materials (curtains, upholstery, etc.),
flammable gases or explosive materials (spray cans) and materials that can be deformed by heat.
•
This appliance must not be used in any type of vehicle or restricted space (lifts, camper vans, cars,
cabins etc.).
• To install the appliance, proceed as follows and refer to the figures:
- The appliance must be fixed in such a way that it is horizontal and the air outlet grid is on the
underside.
- the fixing is provided by means of 2 screws that engage in the 2 "lock hole" slots made on the rear
panel.
17
The secondary