Bimar KPT-2000B 5208LE Notice D'instructions page 20

button. The power depends on the difference between the selected temperature and the
outside temperature and it can vary between 1000W, 2000W or "only ventilation" mode: once
the selected temperature is reached, only the ventilation function will work, when the room
temperature is lower than the selected one, the appliance reactivates the heating.
•
To leave out the set temperature press the
works in this mode without temperature limit. The symbol °C disappears from the display and
the symbol "- -" appears. The appliance will work for 12 hours at the selected power, then it
will work for 30 seconds as "only ventilation" and then go into stand-by.
•
Note:
•
When setting the temperature, an Eco mode will be used = based on the deviation (∆T)
between the requested temperature and the current one; the function activates the power "
" or " " or only Ventilation. If the deviation ∆T > 2°C, "
<∆T≤ 2°C " " is activated; if ∆T=0°C ventilation is activated; the fan will run for 30 seconds to
cool the inside of the unit to protect the components, then it will go into standby mode. If the
room temperature is lower than the value set on the display, it remains in stand-by, while if the
deviation is ≥2°C the fan heater will start working again (hot air).
•
The button on the remote control confirms the selected temperature or the selected time.
Weekly program (only remote control)
•
The button on the remote control: shows the "window sensor" that checks if the
temperature goes down by 5-10°C in less than 10 minutes and if it does it stops the appliance
for 30 minutes and then goes in stand-by.
•
The button on the remote control: chooses the days of the week (d1-d7).
•
The button on the remote control: activates the weekly program.
•
The button on the remote control: selects the start time of the daily program.
•
The button on the remote control: activates the day program with a maximum of 6
periods (P1-P6) .
•
The button on the remote control: selects the stop time of tha daily program.
These functions are regulated with the remote control:
HOUR/MINUTES/DAY setting (appliance has to be on or in stand-by). Press the
should see the number "12" on the display, set the right hour with the
the button again, you should see the number "30"on the display, set the correct minutes with
the and the
correct day with the
button. Press the
and button. (d1=Monday; d2=Tuesday; d3=Wednesday; d4=Thursday;
button and select power I or II: the appliance
button, you should see "
20
+ " is activated; if between 0°C
and the
" on the display, set the
, button, you
button. Press