Publicité
3.3
Preparing the installation location
WARNING
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons in front of the device may be seri-
ously injured.
›
Use only fixing materials that are suitable for the mounting base. The fastening materials supplied are
only to be used for masonry and concrete.
›
Only install the device in an upright hanging position.
›
See the corresponding drawing in chapter 10.5.
Use the leaflet as a drilling template
↻ Have adhesive strips to hand (not in scope of supply).
1 Open the leaflet at the lower right-hand corner and smooth out the marked in-
ner side.
2 Raise the leaflet to the installation location and fix it with adhesive strips at all
four corners.
3 If necessary, adjust the position and height according to [See figure 14]
[} Page 193] and smooth out the leaflet so that the hole pattern is precisely ad-
hered to. (tolerance: 1mm!)
4 Choose a drill bit and drill all the fixing holes to match the holes in the leaflet.
5 Once the wall plugs are in place, the leaflet can be removed and placed back in
the packaging.
» The device is ready for wall mounting.
4
Installation
4.1
Opening the device
↻ The device has been installed on the mount.
↻ Wipe any moisture off the frame of the housing cover using a cloth.
F Undo the 14 screws (2) and carefully remove the housing cover (1) [
F Take care not to damage or soil the seals and fibre optics when setting down
the housing cover.
» Proceed with the installation of the device.
Page 6
Open leaflet
& Strech to fullsize!
1
1
3
5
7
2
4
6
8
Fig. 2: Using the drilling template
1
Leaflet with drill holes
2
Drawing pen (optional)
3
Adhesive strips
T_30]
2
Fig. 3: Removing the housing cover
1
Housing cover
2
Fastening screws
2
3
4
1
B/ M/ MF/ L
Publicité
