Publicité
18 | English
If the status indicator (3) lights up green at the end of the
punching process, the maximum pressure has been reached
and a full punching operation is detected. If the punching
was not successful, the status indicator lights up red.
Status indicators
Colour of the status
indicator (3)
After inserting the rechargeable battery/waking up from sleep mode:
Green (3 s)
Power tool ready for use
Yellow (3 s)
There are fewer than 1000 work cycles re-
maining until the end of the maintenance
interval.
Red (3 s)
Battery too weak for punching process
Battery and/or power tool outside the op-
erating temperature range
After completion of the punching process/during operation:
Green (3 s)
Punching successful
Yellow (continuous)
Maintenance interval of 20,000 work
cycles exceeded
Red (3 s)
No complete punching operation, internal
fault of the power tool or power tool out-
side the operating temperature range
The specific error messages can also be accessed via the
Bosch Read-Out Software.
Reading Out Work Results with the Bosch Read-
Out Software
The power tool saves data such as pressure and working
time for each work process. To read out this data, you need
the Bosch Read-Out Software, which you can download free
of charge from www.bosch-professional.com. Install the
software and follow the installation instructions. In the soft-
ware, you can also see how many work cycles are still out-
standing until the next maintenance interval.
To transfer log entries, open the flap for the USB port (4)
and connect the power tool with your PC via a USB Type-C®
cable. A rechargeable battery must be inserted into the
power tool to access the log entries.
1 609 92A B0Z | (22.11.2024)
Sleep Mode and Restart Protection
For safety reasons, the power tool will be put into sleep
mode in the following cases:
– If it has been more than 5 min since the battery was inser-
ted or the tool has not been used for more than 5 min
after the last punching process,
– If the on/off button (9) is pressed while the battery is be-
ing inserted (as restart protection).
In this case, briefly press the on/off button (9) once to activ-
ate the power tool. Then start the punching process as usual.
Meaning
−
Schedule maintenance with an authorised Bosch
after-sales service centre.
Charge/change battery
Allow the battery and the power tool to reach the
correct temperature range
−
Send the power tool to an authorised Bosch after-
sales service centre for maintenance.
1. Restart the punching process
2. Remove and reinsert the rechargeable battery
3. Leave the power tool to adjust to the ambient
temperature
4. If these measures do not help, then contact an
authorised Bosch after-sales service centre.
Maintenance and Service
Maintenance and Cleaning
Before carrying out any work on the power tool (e.g.
u
maintenance, tool change etc.), remove the battery
from the power tool. There is risk of injury from uninten-
tionally pressing the on/off switch.
To ensure safe and efficient operation, always keep
u
the power tool and the ventilation slots clean.
Keep the power tool dry. Only wipe off any dirt using a damp
cloth.
Only store and transport the power tool in the XL‑BOXX.
To ensure that the power tool is operating safely for as long
as possible, the power tool requires maintenance after
20,000 work cycles, or after 4 years at the latest. Once
20,000 work cycles have been exceeded, the status
indicator (3) will light up yellow continuously.
Send the power tool to an authorised Bosch after-sales ser-
vice centre for maintenance.
Corrective measure
Bosch Power Tools
Publicité
