EMN20010
TEMPORARY ACTION IN
EMH80010
IMPACT DAMAGE
w
The outboard motor can be seriously
damaged by a collision while operating
or trailering. Damage could make the out-
board motor unsafe to operate.
If the outboard motor hits any object in
the water, follow the procedure below;
1) Stop the engine immediately .
2) Inspect control system and all compo-
nents for damage . Also, inspect the
boat damage .
607011
3) However damage is found or not
found, go back to a nearest harbor
slowly and carefully.
4) Have a Yamaha dealer inspection of
the outboard motor, before operating
it again.
EMG65110
POWER TRIM / TILT WILL NOT
OPERATE
If the engine cannot be tilted up or down
with the power trim and tilt because of a
discharged battery or a failure with the
power trim and tilt unit, the engine can be
tilted manually. Loosen the manual valve
screw counterclockwise until it stops. Put
q
the engine in the desired position, then
tighten the manual valve screw clockwise.
411011*
1 Manual valve screw
5-5
EMERGENCY
GB