Inspecting And Replacing Anode - Yamaha 40V Manuel D'utilisation

To clean the fuel tank
1) Empty the fuel tank into an approved
gasoline (petrol) container.
2) Pour a small amount of suitable sol-
vent in the tank. Reinstall the cap and
shake the tank. Drain the solvent
completely.
To clean the fuel filter
1) Remove the screws holding the fuel
hose joint assembly . Pull the assem-
bly out of the tank.
2) Clean the filter (located on the end of
the suction pipe) in a suitable clean-
ing solvent. Allow the filter to dry.
3) Replace the gasket with a new one.
Reinstall the fuel hose joint assembly
and tighten the screws firmly.
902054
EML24010
INSPECTING AND REPLACING
ANODE
Yamaha outboard motor is protected
from corrosion by a sacrificial anode(s).
Check the anode periodically. Remove the
scales from surfaces of the anode.
For the replacement of the anode, consult
604012
a Yamaha dealer.
cC
Do not paint the anode, for this would
render it ineffective.
405011
4-26
GB