Mitsubishi Electric M Serie Manuel D'installation page 18

DETAIL A
2 plastic
ties per side
CORRECT
PLASTIC TIE
5/8"
(15mm)
PLASTIC TUBE
DETAIL A
Step. 10d Next, install the clear plastic tubes
which are included in the accessory bag. En-
sure the plastic tubes drain into the pan. Also,
be sure the clear plastic tubes do not have
any restriction. Cutting of the plastic tube is
required, please refer to the table below for
length. Finally, secure the clear plastic tubes to
the top drain pan per Detail A (see next page)
then to the metal brackets supporting the coil to
the top drain pan with the provided plastic ties
as shown.
Model code Tube Length
12, 18, 24 4.9 in. (125 mm)
30, 36 6.9 in (175 mm)
1
Tube length provided
Specifications are subject to change without notice.
SVZ-KP12, 18, 24, 30, 36NA
2 plastic tubes.
Ensure tubes drain
into pan.
Step. 11 Reinstall the coil assembly along with
INCORRECT
the bracket(s) that secure(s) it. Failure to rein-
stall the brackets will result in capacity loss and
PLASTIC TIE
condensation formation inside the cabinet. Be
sure the thermistor harness is reconnected in-
PLASTIC TUBE
side the coil portion of the cabinet. Refer to 9.3
steps 1 to 4 to reassemble the panels. Ensure
the proper knockouts are removed for drainage
and electrical connections.
1
18
Reattach bracket(s)
Side drain pan on bottom
Thermistor
harness
Leak Sensor
harness
Sharp edges
CAUTION
When routing the thermistor harness, refer to
the image above to prevent damage to the
thermistor harness by avoiding any sharp
edges.
© 2024 Mitsubishi Electric US, Inc.
Electrical knockouts
Motor on bottom
Drain
pan