CAMPAGNOLO SPEED 11 ERGOPOWER EPS CONTROL LEVERS Mode D'emploi page 25

• Levers (B - Fig. 10/11) and (C - Fig. 10/11) can be operated with the hands in
a high or low position on the handlebar.
Moreover, the EPS controls allow to shift gears also when braking.
2.1 - RIDING SETTING and ZERO SETTING
• Pressing the MODE button (D - Fig. 10/11) located on the control of the
rear derailleur or derailleur for about 6 seconds allows to adjust the reference
position of the rear derailleur and derailleur (refer to the directions contained
in the instructions leaflet of the EPS rear derailleur and EPS derailleur).
• Pressing both MODE buttons together (D - Fig. 10/11) for about 6 seconds
allows you to reset the reference position of the rear derailleur and derailleur
to zero
WARNING!
Setting the rear derailleur and derailleur when the bicycle is in motion
may result in dangerous situations and cause accidents. Therefore please
be very careful if you decide to do it.
WARNING!
Resetting the rear derailleur and derailleur to zero is a particularly delica-
te operation and must be carried out when the bicycle is stationary and
placed on a stand. This is why it should be conducted only and exclusively
by a Campagnolo Service Center, a Campagnolo Pro-shop or a mechanic
specialised in mounting EPS groupsets.
ENGLISH 25