Publicité
A
4. Close the oven door to the first opening
position (at approximate angle: 70°).
5. Hold the door with one hand on each side
and pull it away from the oven at an
upwards angle.
6. Put the door with the outer side down on
a soft cloth on a stable surface.
7. Hold the door trim
the door at the two sides and push
inwards to release the clip seal.
2
B
8. Pull the door trim to the front to remove it.
9. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide.
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
22
ENGLISH
A
on the top edge of
1
10. Clean the glass panel with water and
soap. Dry the glass panel carefully. Do
not clean the glass panels in the
dishwasher.
After cleaning, do the above steps in the
opposite sequence. Install the smaller panel
first, then the larger and the door.
Make sure that the glass panels are inserted
in the correct position otherwise the surface
of the door may overheat.
11.11 Replacing the lamp
WARNING!
Risk of electric shock.
WARNING!
Risk of injury when removing the glass
cover.
WARNING!
Risk of burns, the glass cover may be
hot. Use protective glove when touching
the lamp.
1. Turn off the appliance. Wait until the
appliance is cold.
2. Disconnect the appliance from the mains.
3. Use a Torx 20 screwdriver to remove the
glass cover.
4. Remove and clean the metal frame and
the seal.
5. Replace the lamp with a suitable 300°C
heat-resistant lamp.
6. Install the metal frame and the seal.
Tighten the screws.
Publicité
