Gardena 2000/2 Clear 18V P4A Mode D'emploi page 9

To start the pump [ Fig. O1 / O4 ]:
To start:
(8)
1. Open the cover .
2. Put the battery (B) into the battery holder
audibly engages.
3. Close the cover (8) until it engages noticeably.
Make sure that the cover
properly closed.
4. Push the On / Off button
The Pump starts and the battery charge status
indication is displayed.
4. MAINTENANCE
DANGER! Risk of injury!
Injury when the product starts accidentally.
v Remove the battery before you maintain the
product.
To clean the pump:
DANGER! Risk of injury!
Risk of injury and risk of damage to the
product.
v Do not clean the product with a water jet
(in particular high-pressure water jet).
v Do not clean with chemicals including petrol or
solvents. Some can destroy critical plastic parts.
v Clean the pump with a damp cloth.
To clean the filter [ Fig. M1 / M2 / M3 ]:
In order to ensure continuous trouble-free operation, the
(10)
filter should be cleaned at regular intervals.
After pumping dirty water, the filter
immediately.
5. STORAGE
To put into storage [ Fig. S1 ]:
The product must be stored away from children.
1. Remove the battery.
2. Charge the battery.
3. Turn the pump upside down to allow residual water to
flow out.
4. Clean the pump, the battery holder, the battery and
the battery charger (see 4. MAINTENANCE).
5. To save storage space, fold in the bracket and slide the
(11)
battery holder from above onto the intended holder
on the pump.
6. Store the pump, the battery and the battery charger in
a dry, enclosed and frost-free place.
GAR_14600-56.960.02_2024-11-28.indb 9 GAR_14600-56.960.02_2024-11-28.indb 9
(D) until it
(8)
of the battery container is
(s) on the control panel (P) .
(10)
must be cleaned
NOTES:
Depending on the length of the hose and the type
of installation, it may take some time for the pump
to deliver the water.
If the pump does not deliver water after several
suction attempts, there is probably air in the hose.
v Start the pump once briefly in water without
a hose.
To stop:
(s)
1. Push the On / Off button
The Pump stops.
(A)
2. Push the locking button
(D)
from the battery container
(9)
1. Turn the foot anti-clockwise and remove the foot
(bayonet lock).
(10)
2. Turn the filter anti-clockwise and remove the filter
(bayonet lock).
(10)
3. Clean the filter and the foot
(10)
4. Push the filter into the pump so that the lines
are opposite.
(10)
5. Turn the filter anti-clockwise (bayonet lock).
(9)
6. Push the foot onto the pump so that the lines
are opposite.
7. Turn the foot clockwise (bayonet lock).
The pump must not be operated without the filter
To clean the battery and the battery charger:
Make sure that the surface and the contacts of the battery
and the battery charger always are clean and dry before
you connect the battery charger.
Do not use running water.
v Battery charger: Clean the contacts and the plastic
parts with a soft and dry cloth.
v Battery: Occasionally clean the ventilation slots and
the terminals on the battery using a soft brush that is
clean and dry.
Disposal of the product:
(according to Directive 2012/19/EU / S.I. 2013 No. 3113)
The product must not be disposed of to normal
household waste. It must be disposed of in line
with local environmental regulations.
IMPORTANT!
v Dispose of the product through or via your municipal
recycling collection centre.
Disposal of the battery:
The GARDENA battery contains lithium-ion cells
that should not be disposed of with normal house-
hold waste at the end of its life.
Li-ion
(P)
on the control panel .
(B)
and remove the battery
.
(9)
(10)
(9)
under running water.
ß / ß
a1 a2
ß / ß
a1 a3
(10)
.
9
28.11.24 12:36 28.11.24 12:36