Publicité
• Check the material to be shredded carefully. Ensure that it does not contain stones or nails, as
they could seriously damage the shredder.
Watch out for vibrations. Strong vibrations are caused by a damaged or worn cutting roller.
•
Replace the cutting roller if necessary.
7.0 MAINTENANCE AND CARE INFORMATION
• WARNING! Ensure that the shredder is switched off and disconnected from the mains. Wait
until all the moving parts have come to a complete stop and the device has cooled down before
carrying out cleaning and maintenance work.
• Check all the parts for signs of wear. Do not continue to use the product if you find any defects.
• Only have parts replaced with genuine spare parts by a specialist in accordance with the
manufacturer's specifications.
• Have the device inspected and maintained by a qualified service technician. Do not attempt to
repair the device yourself unless you are suitably qualified.
• WARNING! Risk of injury due to dangerous moving parts!
• Always wear sturdy protective gloves to clean the
• To ensure electrical safety, the device must not be treated with or even immersed in liquids.
• Clean the shredder directly after every use. Do not allow shredded material to dry and harden
on the surfaces of the shredder. This has a direct negative effect on the shredding performance.
• Keep the ventilation slots clean and free of dust.
• Oil the
cutting roller
• Brush off dirt and plant residues. Wipe the outside of the shredder clean with a damp cloth.
• Never use cleaning products or solvents. They could cause irreparable damage to the device.
Plastic parts can be damaged by the use of chemicals.
• A lack of care and maintenance can damage the device. Dangerous situations can arise.
• Regular maintenance helps to ensure the safety of the product and increases its service life.
7.1 ADJUSTING THE PRESSURE PLATE
• Note! The pressure plate is set at the factory and should only be adjusted in case of wear or
after loosening if necessary. Wear is recognisable due to the fact that the shredded material is
only crushed and is still connected in chain form.
• Loosen four screws and remove the protective plate.
• Replace the pressure plate
• Refit the protective plate on the shredder and secure with screws.
• Wear is recognisable due to the fact that the shredded material is only crushed and is still
connected in chain form.
2
3
- Set the direction switch to the forward position and switch on the product.
after every fourth or fifth use, using a suitable oil.
1
cutting
roller.
27
www.DEUBAXXL.de
Publicité
