Publicité
Operation
GB
Before first use
IE
Preparing the glue site:
■
Do not use inflammable solvents to clean the
glue site.
■
The ambient temperature and temperature of
the materials to be glued must be not less than
+ 5° C and not warmer than + 50° C.
■
The glue sites must be clean, dry and free of
grease.
♦
Smooth surfaces should be roughened before
gluing.
♦
Warm any materials that are prone to cool
down quickly (e.g. steel) to improve the bond
with the glue.
♦
Screw on the appropriate nozzle
Preparing the tool for use
Working with the mains lead connected:
♦
Connect the mains lead
nection
(see Fig. B).
Insert the mains plug into the mains socket.
♦
Fold forward the plastic stand
Stand the device up.
♦
Push a glue stick into the feed channel
♦
Let the device heat up for about 5 minutes.
The device is now ready for use.
Cordless working:
♦
Connect the mains lead
nection
.
Insert the mains plug into the mains socket.
♦
Place the glue gun into the charger
♦
Push a glue stick into the feed channel
♦
Let the device heat up for about 5 minutes.
The device is now ready for use.
♦
Repeat the heating-up procedure if the feed
switch becomes stiff or the outcoming glue
becomes viscous.
4
All manuals and user guides at all-guides.com
Gluing:
♦
♦
♦
♦
♦
Switching off the device:
.
♦
Changing the nozzle:
■
to the glue gun con-
♦
■
.
.
Maintenance and Cleaning
to the charger con-
The glue gun is maintenance-free.
.
.
■
Press the feed clamp
glue as required for your work.
Apply the glue in individual dots. Apply in zig-
zags on flexible materials such as fabrics.
Immediately after applying the glue, press the
two materials together for about 30 seconds.
The glued joint can be loaded after about 5
minutes.
When you take a break from work, set the glue
gun down on the plastic stand
charger
.
Remove any glue residue with a sharp knife
after cooling. Glued joints can be loosened
again by applying heat.
Pull the mains lead out of the mains socket.
Wear protective gloves.
Heat up the device for about 5 minutes.
Change the nozzle
Danger of burns!
Touch the nozzle
only by the heat shield
The nozzle tip is hot!
NOTE
Hold item upright, tip up, to prevent glue from
flowing out.
WARNING! Pull the mains lead out of
the mains socket before you clean the
tool. Always keep the device clean and
dry.
Do not allow any liquids to enter the tool. Use
a soft cloth to clean the housing. Never use
petrol, solvents or cleaning agents that might
attack plastic.
to regulate the flow of
or in the
when it is hot.
.
PHP 500 C2
Publicité
