Install Blower - Whirlpool W10768191 Instructions D'installation

Install Blower

Install Blower Cover
1. Locate blower motor cover.
2. Run the blower motor wires with strain relief through
the small opening in the blower motor cover, starting
from the inside and feeding out.
3. Feed blower motor wire through opening and place the
strain relief bracket to the inside of the blower cover. Install
and tighten the two (2) provided #8–18 x
secure the strain relief bracket.
4. Reposition the blower motor cover retainer spring
as illustrated.
5. Remove paper from the rear of the rectangular felt pad
6. Apply blower motor cover to the blower. Slightly spread the
Strain relief
⁄ " screws to
3
8
7. Rotate blower motor cover so the bellows are facing
8. Move blower motor wire to the front of the installation.
and apply adhesive side of felt to the bellow flange.
NOTE: This step is important to ensure maximum
blower performance.
cover retainer spring to allow the cover to drop into position
on the blower motor. Ensure the blower cover retainer ring
is securely locked in place.
NOTE: The blower motor cover will not properly install
if the motor wire is on the top of the motor.
Incorrect
Incorrect
towards the right of the installation, and position the
bellows so the bellow flange is facing the floor as illustrated.
Correct Correct
13