Make Electrical Connection; Verify Anti-Tip Bracket Is Installed And Engaged; Oven Door - Whirlpool W10768191 Instructions D'installation

5. Latch the Enclosure Front to the housing by positioning the
front clasps in the slots on the top of the housing; then, push
down on the clasp handles.
6. Install the new Front Lower Access Panel that shipped with
the duct-free kit, by aligning the studs with the keyhole slots
on the range. Press the Front Lower Access Panel forward
into the slots and push downward to engage the studs.
7. See "Replacing Air Filter" section for servicing.

Make Electrical Connection

Plug into grounded outlet. See the appropriate "Electrical
Requirements" section.
Verify Anti-Tip Bracket
Is Installed and Engaged
1. Ensure range is in its final location.
2. Remove the front lower access panel.
3. Use a flashlight to look underneath the bottom of the range.
4. Visually check that the rear range foot is inserted into
the slot of the anti-tip bracket.
5. Replace the front lower access panel.
IMPORTANT: If the range is moved to adjust the leveling legs,
verify that the anti-tip bracket is engaged by repeating steps
1 to 5.
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven
is off and cool. Then follow these instructions.
NOTE: The oven door is heavy.
To Remove:
1. Open oven door all the way.
2. Pinch the hinge latch between two fingers and pull forward.
3. Close the oven door as far as it will shut.
4. Lift the oven door while holding both sides.
To Replace:
1. Insert both hanger arms into the door. Be sure that the
2
2. Open the oven door. The door should be able to open all
3. Move the hinge levers back to the locked position. Check

Oven Door

Repeat on other side of oven door.
A. Hinge latch
Continue to push the oven door closed and pull it away
from the oven door frame.
hinge notches are engaged in the oven door frame.
A
A. Hinge notch
the way.
that the door is free to open and close and is level while
closed. If it is not, repeat the removal and installation
procedures.
A
17