Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Complete Preparation
1. If not yet attached, install the 6" (15.2 cm) vent transition the
top of the range hood liner using two 3.5 x 9.5 mm screws.
2. Locate side mounting bracket flush to the bottom of the
cabinet side and against the inside of the front cabinet face.
Orient the bracket depending on the width of your cabinet
as depicted in the diagrams below. Drill 1/8" (3 mm) pilot
holes in six places, attach a bracket using three 4.5 x 13 mm
screws to each side of the cabinet, and tighten. Additional
washers in hardware package are supplied as spacers for
cabinet walls thinner than 1/2" (13 mm).
Bracket Orientation for 30" (76.2 cm) Cabinet
B
A
A. 30" (76.2 cm) cabinet
B. Screws: 4.5 x 13 mm (6)
C. Washers (optional)
D. Mounting bracket (2) (position for 30" [76.2 cm] cabinet)
Bracket Orientation for 36" (91.4 cm) cabinet
C
A
B
A. 36" (91.4 cm) cabinet
B. Screws: 4.5 x 13 mm (6)
C. Washers (optional)
D. Mounting bracket (2) (position for 36" [91.4 cm] cabinet)
10
C
D
D
3. Install the vent system according to the method needed.
Use caulking to seal the exterior wall or roof opening.
Install Range Hood
WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
1. Using two or more people, lift the hood liner into its mounted
location. Attach with four 4.2 x 19 mm screws into the
slotted openings. Do not tighten screws.
A
A. Cabinet
B. Hood liner canopy assembly
2. If needed, insert spacers between each side of the canopy
and the mounting plate to space and center the canopy
in the cabinet. Align the bottom of the canopy with the
bottom of the cabinet. Install four 4.2 x 19 mm screws into
the round mounting plate openings and tighten all eight
mounting screws.
3. (For some installations):
A filler strip may be required for some cabinets.
Install a filler strip and secure with two 4.5 x 13 mm screws
from inside the front of the hood liner assembly.
A. Screws: 4.5 x 13 mm
B. Filler strip
B
C
D
C. Screws: 4.2 x 19 mm (8)
D. Spacer: optional
B
A
Publicité
Table des Matières
