Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. Drill two ¹⁄
" (3 mm) holes that correspond to the bracket
8
holes of the determined mounting method. See the following
illustrations.
Floor Mounting
Rear position
Wall Mounting
5. Using the two #10 x 1
⁄
5
provided, mount anti-tip bracket to the wall or floor.
6. Move range close enough to opening to allow for final
electrical connections. Remove shipping base, cardboard
or hardboard from under range.
7. Move range into its final location, making sure rear leveling
leg slides into anti-tip bracket.
8. Move range forward onto shipping base, cardboard
or hardboard to continue installing the range, using
the following installation instructions.
Install Recirculation Blower Assembly
Items Needed:
Blower Assembly (located under range)
■
Lower Filter Enclosure (Remove (5) M5 x 15 mm screws
■
to disassemble from Upper Filter Enclosure)
(3) Felt Pads
■
(3) #10 x 1" screws
■
Aluminum tape
■
The anti-tip bracket must be installed. To install the anti-tip
bracket shipped with the range, see "Install Anti-Tip Bracket"
section.
Front position
Diagonal (2 options)
" (4.1 cm) Phillips-head screws
8
Assemble Recirculation Housing
1. Slide the Lower Filter Enclosure over the blower assembly
outlet.
NOTE: Lower Filter Enclosure must be disassembled from
the Upper Filter Enclosure for proper installation.
2. Secure the Lower Filter Enclosure to the blower motor with
the three (3) #8 – 3/8" screws provided. Seal connection with
aluminum tape.
1
Position the Blower
1. Determine and mark the center line on the floor of the
cabinet opening.
A. Center line
2
3
A
11
Publicité
Table des Matières
