Whirlpool W10768191 Instructions D'installation page 22

6. Unscrew the metal cover and unscrew the blue regulator
cap. Keep the washer in place.
A
A. Metal cover
B. Washer
C. Blue regulator cap
7. Flip the blue regulator cap over and screw it back into
the metal cover.
A
A. LP gas position
B. Natural gas position
8. Screw the metal cover securely back into place.
Do not overtighten.
To Convert Surface Burners (LP Gas to Natural Gas)
1. If they are installed, remove the burner grates.
2. Remove the burner caps.
3. Remove the burner base.
A
A. Igniter electrode
B. Burner cap
C. Gas tube opening
D. Burner base
22
4. Apply masking tape to the end of a
A
B
C
5. Gas orifice spuds are stamped with a number on the side.
B
Natural Gas Orifice Spud Chart
Burner Rating
19,000 BTU (ST)
17,000 BTU (ST)
17,000 BTU
15,000 BTU
9,200 BTU
B
8,000 BTU
5,000 BTU
C 1,200 BTU
D
NOTE: Refer to the model/serial/rating plate located on the
oven frame behind the top right-hand side of the oven door
for proper sizing of spuds for each burner location.
6. Place LP gas orifice spuds in the orifice spud bag.
7. Replace the burner base.
8. Replace the burner cap.
9. Repeat steps 1 to 7 for the remaining burners.
to help hold the gas orifice spud in the nut driver while
changing it. Press nut driver down onto the gas orifice
spud and remove by turning it counterclockwise and
lifting out. Set gas orifice spud aside.
B
A
C
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
Replace the LP gas orifice spud with the correct Natural Gas
orifice spud.
A. Stamped number
Refer to the following chart for the correct Natural Gas
orifice spud placement.
Color
White/Gray
N/A
White/Blue
White/Green
White/Black
White/Yellow
White/Orange 1.00
Black
IMPORTANT: Keep the LP gas orifice spuds in case
of reinstallation with LP gas.
⁄ " (7 mm) nut driver
9
32
D
A
Size (mm) ID Number
1.84 184
1.75 175
1.90 190
1.80 180
1.35 135
1.25 125
100
0.52 52