Whirlpool W10768191 Instructions D'installation page 20

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To Convert Gas Pressure Regulator
(Natural Gas to LP Gas)
1. Move the range out from the wall.
2. Locate the gas pressure regulator at the lower right
corner on the back of the range.
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
3. Remove the front lower panel of the range.
4. Disconnect the blower motor electrical connections.
5. Disconnect the downdraft blower bellows from the range.
6. Unscrew the metal cover and unscrew the blue regulator
cap. Keep the washer in place.
A
A. Metal cover
B. Washer
C. Blue regulator cap
7. Flip the blue regulator cap over and screw it back into
the metal cover.
A
A. Natural gas position
B. LP gas position
8. Screw the metal cover securely back into place.
Do not overtighten.
20
A
A
B
C
B
To Convert Surface Burners (Natural Gas to LP Gas)
1. If installed, remove the burner grates.
2. Remove the burner caps.
3. Remove the burner base.
A
A. Igniter electrode
B. Burner cap
C. Gas tube opening
D. Burner base
4. Apply masking tape to the end of a
to help hold the gas orifice spud in the nut driver while
changing it. Press nut driver down onto the gas orifice spud
and remove by turning it counterclockwise and lifting out.
Set gas orifice spud aside.
B
A
C
A. Igniter electrode
B. Orifice spud
5. Remove the orifice spuds shipped in the literature package
in the oven. Gas orifice spuds are stamped with a number,
marked with 1 or 2 color dots, and have a groove in the hex
area. Replace the Natural gas orifice spud with the correct
LP gas orifice spud.
A. LP groove
B
C
D
" (7 mm) nut driver
9
32
D
C. Orifice spud holder
D. Screws
A

Publicité

Table des Matières
loading

Table des Matières