Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The Microwave oven is set for recirculation installation. For wall
or roof venting, changes must be made to the venting system.
NOTE: Skip below sections if you are using recirculation
installations. Go to section "Locate Wall Stud(s)". Keep the
damper assembly in case the venting method is changed or the
microwave oven is reinstalled in another location where wall or
roof venting may be used.
Wall Venting Installation Only
1. Using diagonal wire cutting pliers, gently snip out the
rectangular vent covers on the damper plate.
A
A. Diagonal wire cutting pliers
B. Damper vent covers
INSTALLATION INSTRUCTIONS
B
Install Damper Assembly
(for wall venting only)
1. Check that damper blade moves freely, and opens fully.
2. Position the damper assembly on the back of the microwave
oven so that the damper blade hinge is at the top, and the
damper blade opens away from the microwave oven.
A
B
C
A. Back of microwave oven
B. Damper assembly
C. Damper blade
D. Sheet metal screw 5/32" x 5/16" (4 mm x 8 mm)
3. Secure damper assembly with two sheet metal screws
5/32" x 5/16" (4 mm x 8 mm).
Roof Venting Installation Only
1. Remove screws attaching damper plate to top of microwave
oven exterior. Slide damper plate toward the front of the
microwave oven and lift up.
A. Screws
B. Damper plate
D
A
B
5
Publicité
Table des Matières
