Publicité
PROPANE TANK, HOSE, & REGULATOR
Use LPG (propane) only and no other fuels. This oven is supplied and must
be used with an approved 2.8 kPa low pressure regulator and hose only.
Use a certified tank only (not supplied).
Prior to every use, inspect the gas hose. In order to provide a free flow of
gas, the hose should hang freely, be under no tension, with no bends, folds,
twists, knots, or kinks.
The hose should be free of cuts, cracks, and excessive wear. If damaged,
it must be replaced with a Model No. XD01 regulator/hose. The hose
should be no longer than 48" (122 cm).
CONNECTING THE TANK
Ensure the valve on your tank is closed. Ensure the control knob on the
oven is in the "OFF" position.
Connect the hose to the back of the oven. Hand tighten first, then use an
appropriate wrench to make the connection snug — do not overtighten.
Connect the regulator to your tank — hand tighten only.
Do not use tools to connect the regulator to the tank.
Check for and clear any debris at all connection points.
Perform a leak test (see later in this manual).
Position your tank at least 24" (61 cm) away from any surface of the oven.
Do not place the tank or hose under the oven. Keep the tank upright. Do
not use an overfilled tank.
Keep clear of the hose. Walk around, not over it, to prevent tripping hazard.
Keep the hose clear of any hot surface.
If not using your oven for an extended period, ensure tank valve is closed
and disconnect your tank. Do not store the tank indoors.
- 7 -
Publicité
