Publicité
Use a long lit match or lit butane lighter. Place the flame near the burner
orifices closest to the front of the oven (not at the end of the burner). This is
where the gas first enters the burner tube. Access this area through the
door opening or through one of the vents on the left side of the oven.
Press and turn the control to HIGH. Once the gas reaches your flame, it will
ignite. This should only take a few seconds.
Never light the oven with the door in place.
Always allow any residual gas to completely clear before introducing a lit
flame.
For clarity, diagram does not show the bottom grid, however, never operate
the oven without the bottom grid in place.
CHECKING THE FLAME
Inspect the flame at the burner every time you use the oven. A good flame
should be blue with minimal yellow tipping.
Turn the knob from HIGH to LOW. You should see a smaller flame on LOW
than on HIGH. If not, this may be an indication of a gas leak. Close the tank
valve, turn the control knob to OFF, wait for the flames to extinguish, wait
for the oven to completely cool, and then check the burner, tank and
connections as described in this manual.
If you cannot rectify any issues you are experiencing by following
the instructions in this manual, do not attempt any repairs yourself.
- 11 -
Publicité
