Replacing A Bulb; Troubleshooting; Cleaning And Care; Disposal - LIVARNO LUX 89559 Instructions D'utilisation Et Consignes De Sécurité

Preparing for use / Troubleshooting / Cleaning and care / Disposal

Replacing a bulb

DANGER TO LIFE FROM ELECTRIC SHOCK!
Before carrying out any tasks on the lamp, switch
off the electrical circuit at the circuit breaker box
or remove the fuse from the fuse box.
Allow the lamp to cool down completely.
Loosen the screws
and carefully tilt the front panel
Carefully remove the defective bulb
insert a new bulb
10
max 23 W spiral shaped light bulb, E27,
220 -240 V ∼). Ensure that the bulb
screwed into the socket.
Tilt the front panel
with the screws
1
Switch the electric circuit back on at the circuit
breaker box or reinstall the screw fuse in the
fuse box.

Troubleshooting

Note: The motion detector
winter.
Error
Cause
Solution
The light does not turn on.
The bulb is defective.
10
Replace the bulb
10
The motion detector
detection area.
Reorientate the motion detector
The electrical connection is defective.
Have the electrical connection checked by an
electrician.
The lamp switches rapidly on and off.
Eliminate the other light source.
Eliminate the other light source.
There are white or reflective surfaces in the
detection area.
Eliminate the interfering surfaces.
42 GB
with a Phillips screwdriver
1
downwards.
9
. Now
10
(energy saving bulb,
is firmly
10
upwards again and fix it
9
.
is more sensitive in
8
.
is not orientated at the
8
.
8
The lamp does not switch off.
The sensor sensitivity is set too high.
Turn the rotary control SENS
to decrease the sensor sensitivity.
There are people or objects in the detection area.
Remove them.
The lamp oscillates in the wind. The motion
detector is continuously triggered.
8
Install the lamp on a stable, solid surface.
There is something in the detection area that
causes a change in temperature (e.g. sun, water,
air conditioning unit, heater).
Reorientate the motion detector

Cleaning and care

DANGER TO LIFE FROM ELECTRIC
SHOCK! Before carrying out any tasks on the
lamp, switch off the electrical circuit at the cir-
cuit breaker box or remove the fuse from the
fuse box.
DANGER TO LIFE FROM ELECTRIC
SHOCK! For electrical safety reasons, never
clean the light with water or other fluids nor im-
merse it in water. When cleaning, only use a
dry, lint-free cloth.
Do not use solvents, petrol or the like.
Allow the lamp to cool down completely.

Disposal

The packaging and ancillary packing
consist entirely of environmentally friendly
materials. They can be disposed of at
your local recycling facility.
Do not dispose of electrical
equipment in the household
waste!
In accordance with European Directive 2012 / 19 / EC
relating to old electrical and electronic appliances
and its translation into national law, used electrical
anticlockwise
15
.
8