Publicité
Typical Installation
TO POWER SUPPLY
PRESSURE TANK
MOTOR CONTROL BOX
FUSED DISCONNECT
(IF 3-WIRE INSTALLATION)
SWITCH
WEATHERPROOF
JUNCTION BOX
Electrical Information
EN
CABLE SPLICING INSTRUCTIONS
10' OR MORE
=
1. Caretully strip insulation from wires to fit connector. Ba careful
TO KEEP OUT
Et
iru
|
not to cut wire. Clean wire and insutation with sandpaper,
SEDIMENT
SESS
2. Insert connector on wires and crimp connector to wire. Be
certain color code of wires are matched. Whenusing Number B.
and larger wire, the connection should be soldered after being
crimped. DO NOT use acid solder.
4. Complete splice with at least four tightly wrapped overlapping
layers of waterproof tape. Do NOT bend wires while taping, as
wires may break.
MECHANICAL SPLICE KIT*
* Mechanical Splice Kits may be available from local distributors.
Page 6
Publicité
